vernic:
Vlmax:
Vicos:
это не искажения, а АЧХ
АЧХ бывает ровненькой, а звук такой, что слушать нельзя.
самая красивая АЧХ без кассеты, в режиме источник
Добавлено спустя 6 минут 18 секунд
Я думаю, что все давно поняли что я хотел сказать этими картинками.
Если хорошенько покопаться в схеме, то можно будет понять еквалайзер это или подмагничивание. Но я ж говорю, запись этим знанием в магнитофонах с одной крутилкой "биас" не улучшить.
упрямый vernic!
это эквалайзер!!!
Добавлено спустя 32 секунды
А вот описание работы!
Добавлено спустя 1 минута 22 секунды
Вот тебе английский текст для перевода!
Recording Equalization Calibration
Although bias current and equalization are automatically set
by the Automatic Tape Selection (ATS) function for the tape
being used, you can use the REC EQ CAL switch to change
the recording characteristics according to the nature of the
source material or to compensate for the particular
characteristics or the tape.
To emphasize higher frequencies In
recordings
For normal recordings
To dampen higher frequencies in
recordings
Bias calibration recording
Use the REC EQ CAL switch In conjunction with the BIAS
control to modify bands of sound and record according to the
tape's characteristics.
* When recording music which has strong middle and
low frequencies
Set the bias at flat with the REC EQ CAL switch set in the
HIGH position to increase the bias current.
Adjust the BIAS control so that the HIGH and LOW meters
indicate equal readings.
* When recording music which has strong high
frequencies
Set the bias at flat with the REC EQ CAL switch set in the
LOW position to decrease the bias current.
Adjust the BIAS control so that the HIGH and LOW meters
Indicate equal readings.
Note
With metal tape, because the amount of frequency
characteristic modulation is not In proportion to that of the
bias, the optimum bias current may not be obtained using the
methods above.
Another use or the REC EQ CAL switch
When using special tapes. adjusting the BIAS control with
the REC EQ CAL switch set in the NORMAL position may
not result in equal readings on the HIGH and LOW meters. If
this occurs, adjust the BIAS control after setting the REC E0
CAL switch to HIGH or LOW.
Добавлено спустя 2 минуты 31 секунда
============================================================
Вот предназначение REC EQ CAL (первые абзацы перевода)
============================================================
Калибровка выравнивания записи
Хотя ток смещения и выравнивание автоматически установлены функцией автоматического выбора ленты (ATS) для используемой ленты, вы можете использовать переключатель REC EQ CAL для изменения характеристики записи согласно природе исходного материала или компенсировать частную характеристику ленты.
Подчеркнуть более высокие частоты в записи
Для обычных записей
Для подавления высоких частот в записи
Bias calibration recording
Используйте переключатель REC EQ CAL в сочетании с управлением Bias для изменения окраски звука и записи в соответствии с характеристикой ленты.